|
|
Posted by punchfast on 11/28/05 18:28
Hey Rick,
I found this article on:
http://esupport.sony.com/perl/model-faq.pl?mdl=DCRTRV330
note steps 4 & 5 indicate the hardware hook up is done with both OFF.
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++
How to connect a digital SONY camcorder to a computer using an i.LINK
connection (IEEE 1394).
Follow this procedure to connect a digital camcorder to a computer using an
i.LINK connection (IEEE 1394).
IMPORTANT: The computer must have an i.LINK (IEEE 1394) port and compatible
video capture software installed.
NOTE: The i.LINK ports may have four or six pin connections. Sony digital
camcorders use i.LINK ports with four pins. Consult the computer or capture
card manufacturer for the specifications of the i.LINK port on the
computer.
1.. Verify that the tape that is being used actually has video recorded on
it, and that it is rewound.
2.. Connect the i.LINK cable to the digital camcorder.
3.. Connect the other end of the i.LINK cable to the computer.
4.. Turn on the computer.
5.. Turn on the digital camcorder.
6.. Start the video capture software on the computer.
NOTE: Image capture should be available if the computer hardware and
software are configured correctly. If image capture is not available,
consult the computer or capture card manufacturer for assistance
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
hope it helps you.
PF
++++++++++++++
"Rick Merrill" <rick0.merrill@NOSPAMgmail.com> wrote in message
news:n8-dnasf2cJq3hbeRVn-og@comcast.com...
> punchfast wrote:
>> Hey Rick,
>>
>> be sure and have computer and camera off when you do this, and verify
>> which way is correct for cable into computer.
>>
>> good luck.
>>
>
> Got it: No Hot Socket.
>
> But I thought firewire Was hot-socket capable?
>
>
Navigation:
[Reply to this message]
|