|
|
Posted by Jer on 11/05/05 12:22
Serial # 19781010 wrote:
> Ripped a film using my usual process:
> DVDshrink using deep analysis and AEC (smooth) and burned with Nero.
> The compression was in the low 60 percent.
>
> Played disk on computer using PowerDVD 5. Motion was very rough,
> jerky, and unnatural. Looked like it was dropping frames.
>
> Took the same disk and played it on my Pioneer stand alone player and
> recorder, two different machines, and motion was nice and fluid and
> natural - no problems.
>
> Anyway took the burned disk and made an image file of it (nrg) and
> mounted it on a virtual Deamon Drive and then played it through
> PowerDVD. Same poor motion. My conclusion is that it is not a hardware
> problem.
>
> Do I need to update some code in windows or perhaps PowerDVD to clear
> up this problem?
>
> After almost 400 burns this is the first time I noticed this
> difference between playing on computer and on the stand alones and I
> would like to be able to depend on the computer playback to give my an
> accurate idea of how good my burns turn out.
>
> What do you think is the problem?
There's only a limited amount of copyright violations embedded in any
given playback system. Once this limit is exceeded, all bets are off.
--
jer
email reply - I am not a 'ten'
Navigation:
[Reply to this message]
|