|
|
Posted by come_mon_come_mon! on 12/15/05 15:48
smh 寫道：
> . --------------------------------------
> Mike Richter, were you born with
> "Scam Artist" emblazoned on your face?
> --------------------------------------
>
> "come_mon_come_mon!" wrote:
> >
> > smh 寫道：
> >
> > > Go into the BIOS, and check the drives are recognized and set to
> > > something like Auto or Enable.
> >
> > I found no similar setting, every time I insert a H/W component into
> > the IDE bus, BIOS will automatically display it's configuration (e.g.
> > LG GSA-4167B...) as PC started up.
>
> What do you have in the BIOS setup if not AUTO or Enable?
If you talked about IDE master slave setup, I could tell you that the
BIOS automatically displayed what it detected, that's it. I couldn't
press key to change the setting shown.
>
> > > Then check the drives are on DMA:
> > >
> > > Control Panel, Sytem, Hardware, Device Manager, Ide Ata/Atapi
> > > Controllers, Primary or Secondary IDE channel, Advanced tab
> >
> > Checked, it's DMA mode 2.
>
> What's the DMA mode of Sony?
Also DMA mode 2
Navigation:
[Reply to this message]
|