| 
	
 | 
 Posted by st.lucky on 04/08/07 15:34 
Thanks a lot for your wonderful idea but I don't understand fine where 
I can add that switch. 
Then the MOBIL RACK that you reccomend me is for one HD. I will have  
2 HDs in RAID0. 
Thanks again 
 
>>> Personally I would mount the drives inside the PC and run them off the  
>>> internal SATA connections.  If you are worried that using your PC for  
>>> internet access might put your data at risk then buy good virus and  
>>> security software.  Alternatively buy a Mac. 
>>  
>>  
>> Thanks alot for your advice. But I don't understand your writings. 
>> If I don't make video editing for one or two mounths but I use my PC 
>> for internet surfing only, why would have to mont the drivers inside 
>> the PC? I think the heat will  damage them (a little bit) and however 
>> even if I will not use them for two mounths, they will works a little 
>> bit. 
>> Do I make a mistake? 
>> thanks again 
> 
>Another option is mount the drives internally but run a switch to turn  
>power to the drives on and off, this way if you aren't using PC for  
>editing at the moment, turn switch off, boot up the PC and the sata  
>controller will not detect the two raid 0 drives and boot up without them. 
>Using only the one system drive, saving you energy cost, heat build up  
>and possibly drive wear and tear, since they aren't spinning up at all. 
> 
>Don't switch them on however while the PC is running unless you have the  
>controller has hot swap feature, most onboard, don't. 
> 
>So just reboot with switch on, and the 2 drives will be detected and you  
>are set for video editing. Simple. No need for external case this way  
>also. I do something similiar, I have a large SATA drive that I only  
>turn on and allow to be detected when doing system backups, then run PC  
>most times with it switched offm not powered up yet all plugged in and  
>not detected by bios. 
>You can use a regular radio shack, on/off switch inline with 12v wire,  
>or a double pole double throw switch to cut both 5v and 12v power going  
>to internal drive or drives. 
>And then also you can get same effect using slide out drawer for about  
>$19, LIKE THIS sata MOBIL RACK 
> 
>http://www.newegg.com/Product/Product.aspx?Item=N82E16817998001 
> 
> 
> 
>Good Luck, AnthonyR.
 
  
Navigation:
[Reply to this message] 
 |