|
|
Posted by Eric on 10/08/07 18:32
I am thinking about going through and re-timing a system, everything
on it that needs to be sync'd other than the cameras runs through a
router (the cameras run through a switcher to the router). Any
suggestions on how to go about re-timing the entire system so that
everything is in-phase? We have a master sync generator that also
generates test patterns (usually left set on SMPTE BARS w/ ID
window). (NTSC). We have a waveform monitor and vectorscope on a
router output along with a loop-out to a professional monitor.
Any and all suggestions would be appreciated (order of doing things,
oddities to look out for, tips on quick and reliable ways to time the
system, etc).
Thanks,
Eric
Navigation:
[Reply to this message]
|