|
|
Posted by Richard Crowley on 10/08/07 20:23
"Eric" wrote ...
> "Richard Crowley" wrote:
>> It depends a lot on exactly what your equipment configuration
>> is, and on what problem you are trying to resolve? Did you
>> just inherit this system? Who set it up? Who maintained it
>> before? Is it documented?
>
> Its timing has been slipping for some time and a recent power failure
> caused certain devices to lie far out of sync. Some outputs appear to
> have the burst 180'd when viewed on the vectorscope. The
> configuration is fully routable, with three tbcs for non-sync'd
> sources, a few decks that need to be synced, a switcher and cameras
> that need to be synced.
Was it designed properly? How can you establish the timing
when it changes by going through a routing switcher. Maybe
the kind of thing you need an experienced tech on-site to figure
out. Unless you have a complete equipment list and block
diagram of the system?
Navigation:
[Reply to this message]
|