Posted by Richard Crowley on 11/11/05 18:16

"ALR" wrote...
> My broadcast monitor produces horrible output after calibration.
> Details:
>
> -I've successfully implemented the instructions from
> http://www.synthetic-ap.com/tips/calibrate.pdf (bars match on blue
> only, blacks adjusted etc). Used SMPTE bars from Premiere Pro 1.5
> -The output to the monitor looks terrible now that it's "calibrated."
> Way too much green.
> -Also, there is some yellow bleeding into the left margin of the white
> bar on the lower left, both before and after calibration.
>
> I bought the monitor used. I have a budget for some service if
> needed.
> It is a JVC BM-H1300SU. Thanks much for any advice, ALR

The server appears to be down, so I don't know what that document
says. However, if you only adjusted the user controls (brightness,
contrast, chroma gain ("color"), and chroma phase ("tint"), then
you likely need a more complete "calibration". There are several
secondary controls (similar to separate brightness and contrast
controls for each of the colors: RGB). These are internal and
should not be adjusted without the proper optical test equipment.

[Back to original message]