Posted by Serial # 19781010 on 11/05/05 11:00

Ripped a film using my usual process:
DVDshrink using deep analysis and AEC (smooth) and burned with Nero.
The compression was in the low 60 percent.

Played disk on computer using PowerDVD 5. Motion was very rough,
jerky, and unnatural. Looked like it was dropping frames.

Took the same disk and played it on my Pioneer stand alone player and
recorder, two different machines, and motion was nice and fluid and
natural - no problems.

Anyway took the burned disk and made an image file of it (nrg) and
mounted it on a virtual Deamon Drive and then played it through
PowerDVD. Same poor motion. My conclusion is that it is not a hardware
problem.

Do I need to update some code in windows or perhaps PowerDVD to clear
up this problem?

After almost 400 burns this is the first time I noticed this
difference between playing on computer and on the stand alones and I
would like to be able to depend on the computer playback to give my an
accurate idea of how good my burns turn out.

What do you think is the problem?

[Back to original message]