Posted by Bob on 11/27/05 17:48

On Sun, 27 Nov 2005 17:09:40 GMT, "Funfly3" <dontemailme@ntlworld.com>
wrote:

>Hi I have a Bush DVD DVR3003 recorder and I brought some DVD+R RW disks, 2
>questions should I be able to read the disks on a PC and how do you erase
>them as they cannot be seen by my PC and the recorder refuse to erase them

Assuming the unit is designed to use DVD+RW disks, it sounds like the
unit is defective. You might try a full erase with a DVD burner on
your computer and then do a reformat with the DVR3003. Try several
times by cycling the tray. Make certain the tray and disc are clean.

I have an ILO DVDR05MU and it works just fine with Verbatim DVD+RW
discs after I did a full erase and reformat on each disc. There is a
newer model out, the MU1, so I got one to evaluate but right out of
the box it has trouble with the same +RWs. I did a full erase and
reformat and it still acts up. I will consult with ILO Tech Support
because it may be a firmware issue. If not, back it goes to WM.


--

"One must realize that the world is a network of real and virtual
combat zones where the stakes are high, struggle is the primary
mode of being and only total victory is acceptable.
-- Sun Tzu, "The Art Of War"

[Back to original message]