|
|
Posted by Jrn Jensen on 12/08/05 10:24
Question regarding DVDSHRINK V3.2...
I have observed, during the encoding process of a movie: The first time I
encode the movie, DVDSHRINK encodes with a rate of approx. 12,000 KB/s - and
the encoding process takes approx 10 minutes...
Now, if I immediatly then try to encode the same movie again, using the same
reader and same parameters, the encoding process now only runs with a rate
of approx. 4,000 KB/s - and naturally takes longer. - A reboot of the system
and running DVDSHRINK again now raises the rate up to approx. 12,000 KB/s
again.
Howcome the second encoding lowers the bitrate ? The drive is hardcoded to
ULTRA DMA (not PIO which would explain the difference) - is it a problem
with the DVDSHRINK, the ATAPI driver or something else ?
Looking for clues...
Cheers,
Joern.
[Back to original message]
|