Posted by Mike S. on 08/19/06 11:57

In article <1155974634.543919.4990@74g2000cwt.googlegroups.com>,
rtungate <rtungate@hotmail.com> wrote:
>Hi everyone
>
>i am a newbie, so i should state that i spent a good couple hours
>searching for an answer before i posted, so if this has been answered a
>million times before and i am wasting your time, i sincerely
>apologize...
>
>i recently bought a tru-tech tt 320 from target on the advice of a
>friend. we took it back to his house and set it up. we did the hack
>that allows you to reset the region code, and tested it. it worked. we
>watched a little bit of "until the end of the world".
>
>so i took it home, hooked it up to mine, and ordered some region 2
>dvds. they started showing up today. you probably already know the
>problem...
>
>i put the disc in, and it scrolls, just as if i were vwatching it on a
>region 1 locked dvd player. i checked the region setting, and its still
>set at 0. i am assuming it is the tv, although i was under the
>impression that the dvd player would convert the pal signal to ntsc for
>an ntsc player.
>
>is there anyone who has any advice, or is this just a case of having to
>buy a new tv?

Go to the video setup menu and change the output from "auto" to "NTSC".

[Back to original message]