Posted by name on 11/01/06 09:58

el_steak wrote:
> My girlfriend has a Sandisk Digital Audio Player (SDMX1-512)
> (http://tinyurl.com/7w9jq)
>
> It went dead a few weeks ago. It would simply not power up, even when
> using a fresh new battery. She would press the power button and nothing
> would happen (no, the "HOLD" was not on;)
>
> I opened it up to see if there wasn't anything obvious broken inside
> but everything seemed to be fine ... except for the presence of a tiny
> button-cell battery (the type you have in your watch) soldered to the
> PCB board.
>
> I checked the voltage of the tiny battery and sure enough it was near
> dead (0.4 volt). I hooked up a regular 1.5volts battery to the (+) and
> (-) of the button cell and bingo, the player came back to life.
>
> After seeing that, I simply soldered 2 pieces of wire from the (+) and
> (-) of the dead battery to the (+) and (-) of the main battery
> terminals. The player works fine now.
>
> I'm really puzzled as to what is the purpose of this battery. Is it
> used for anything important in the player or is it just built to make
> sure that once the battery is dead, you have to buy a new player?

I think the first thing you should do when an mp3 player 'goes dead' is
to try and refresh the firmware. I've had a couple of mp3 players so
far and it
has happened occasionally they seem unresponsive (refusing to turn on
or displaying a permanent error msg), even when I put in a fresh
battery. They tend to come back alive and function perfectly again when
I refresh the firmware.

[Back to original message]