Posted by cbx on 11/11/06 13:32

I was able to finally find White Springs TV on IA7 by tuning in on
the STAR BAND transponder, which I didn't know I could tune in
on this old receiver. Once I located IA7 (WOW, what a signal
STAR BAND HAS), did a blind scan and it found White Springs.

I found some update software for the old Satwork receiver, but
the last update was 2004, so will probably have to do the long
process of swapping over to the new Pansat receiver.






On Sat, 11 Nov 2006 05:46:52 -0600, cbx <nospam@nospam.com> wrote:

>I tried to scan in AMC3 satellite, and whenever the blind scan OR the
>transponder scan gets to a PBS channel, the scan locks up, and the
>only way out is to power down. This works on T21, T24, etc. I also
>have been unable to get Montana or Louisiana PBS or any of the other
>FTA DVB just on this satellite.
>
>Anyone know if this receiver can be flashed to allow it to receive
>PBS?
>
>I have a few Pansats, but don't want to go through the whole
>programming process again if I can flash this one.
>
>Also have been unable to get White Springs TV on IA7, TP14.
>Is anyone else receiving this on their FTA receiver? I receive all
>the channels on Galaxy 10 R and most other satellites, so am pretty
>sure the arc is tracking OK. Any help appreciated.
>
>I am suspecting the non-standard audio and HDTV on the PBS channels on
>AMC3 might be confusing this old receiver.
>
>How would I go about finding out if there is a software flash for this
>receiver, I bought it from Adventist Satellite .
>
>Thanks,
>

[Back to original message]