Posted by Richard Crowley on 10/08/07 18:38

"Eric" wrote ...
>I am thinking about going through and re-timing a system, everything
> on it that needs to be sync'd other than the cameras runs through a
> router (the cameras run through a switcher to the router). Any
> suggestions on how to go about re-timing the entire system so that
> everything is in-phase? We have a master sync generator that also
> generates test patterns (usually left set on SMPTE BARS w/ ID
> window). (NTSC). We have a waveform monitor and vectorscope on a
> router output along with a loop-out to a professional monitor.
>
> Any and all suggestions would be appreciated (order of doing things,
> oddities to look out for, tips on quick and reliable ways to time the
> system, etc).

It depends a lot on exactly what your equipment configuration
is, and on what problem you are trying to resolve? Did you
just inherit this system? Who set it up? Who maintained it
before? Is it documented?

[Back to original message]