|
|
Posted by robin on 12/31/05 16:58
hi
i have disabled region coding.
i tried a hack on the hdcp protection but not sure if it worked, player did
not do anything afterwards.
what was the sequence you used. ?
thanks
robin...
"Okuda" <d.fooks@blueyonder.co.uk> wrote in message
news:aAstf.42520$D47.6624@fe3.news.blueyonder.co.uk...
> I've got the same DVD player, have you disabled the HDCP and the region
> coding on it..? If NOT then the upscaling should not work through the
> componet outputs only the HDMI socket, otherwise I would say that your
> player or projector is faulty..?!? As my plasma TV can display all modes
> upto 1080i (abit they are downscaled by the TV..?? :( ) but in the correct
> aspect ratio from my HD850.
>
> Daz
>
>
> "robin" <none@temp.com> wrote in message
> news:dp3ihn$rr4$1@nwrdmz03.dmz.ncs.ea.ibs-infra.bt.com...
>>I have just purchased a HD850 player & connected it via component leads to
>>my projector.
>>
>> However though my projector will go upto 1080p when i put 720p out I get
>> a 4:3 image shifted to the left of screen & blank screen if I output
>> 1080i.
>>
>> If I use 768p I get full screen and great picture.
>>
>> However my projector tells me it is a 520p signal.
>>
>> I am a little confused.
>>
>> is it because I am using component rather than HDMI connections ?
>>
>> or is it some form of copy protection or incompatibility ?
>>
>> any ideas
>>
>> thanks
>>
>> Robin..
>>
>
>
Navigation:
[Reply to this message]
|