|
|
Posted by Richard Crowley on 10/05/14 11:28
<leekazimir@gmail.com> wrote in message
news:1128523019.278285.277680@o13g2000cwo.googlegroups.com...
> Richard wrote:
>
> ":1) You have a "fixed" zoom window but the subject inside
> wanders around or in/out of this frame.
>
>
> 2) Your zoom window doesn't stay in the location you want.
>
>
> Please clarify which one you mean as the solutions are very
> different. "
>
> You're absolutely right, my language was ambiguous. Let me be more
> specific.
>
> When I have used the Motion option, I've been able to zoom in on a
> spot
> in the video.
>
> However, the Motion option also causes the Zoom window to move all
> around in the frame.
>
> In other words, and to return to my theoretical example, the Zoom will
> move from the poltician's face down to the podium, over to the right
> hand corner of the screen, back to his face, etc.
>
> It doesn't have to do with shaky footage because these are tripod
> shots. What I want is to be able to specify a certain part of the
> image (say, a 150 x 150 box in the dead-center of the image) and to
> never have the Zoom leave that spot until I specify otherwise.
>
> Richard, your advice about the Time Slider sounds as if it would
> work... I do remember using that tool when trying to fix Motion but I
> could not figure out how to make it stay in one spot. Would your
> advice do what I am looking for? I won't be able to work on the
> project till the weekend, but any advice I can have going into it
> would
> help greatly.
Go back and read my original response. The trick is to use
the time silder with only two "keyframes", one at the beginning
of the shot, and one at the end. Then set up you zoom at the
beginning, note all the setting numbers, and go to the end and
enter exactly the same numbers. Do NOT set any key-frames
anywhere else in the timeline of the shot. Your zoom will stay
rock-solid for the length of the shot.
Navigation:
[Reply to this message]
|