|
Posted by Eddard on 09/15/05 21:05
Are you supposed to manually set the satellite positions or are the already
preprogrammed?
When I try to set up to receive a signal on any satellite is the receiver
supposed to move the motor to the correct position or do I have to manually
move the position with the move controls then store it?
When I use the move continuous buttons the motor does move the dish east and
west.
I am in the Albany, NY area using the Hotdish75 and cannot find any signals
either. I have tried re-adjusting the antenna position of true south.
Also the SG-2100 manual doesnt show where exactly on the shaft to mount a
Hotdish75.
Any help would be appreciated.
Navigation:
[Reply to this message]
|