|
|
Posted by arcadefreaque on 09/18/05 00:32
I'm hoping that someone here can take a glance at my info below and be
able to quickly say "yeah" or "no way" and maybe give me some advice.
I know a bit about sat stuff. Was in it way back in c-band days, but
there is so much hacking crap to wade through and way more various
equipment that I can't tell what I'm getting into.
Basically, I want to know if I can use my 20" dvb dish (with a new lnb,
I presume since I still have the circular polarity one from when I was
a dishnet subscriber on there now) with the Pantec ultra (pansat/fortec
clone) to recieve BYUTV (the only thing I want with the DVB)
Here's the info on where I plan to snag the dvb signal for BYUTV -
* Telstar 5 ch. 11
* Downlink 3934.80
* 3.648 mb/s
* tag 0 (or tag 15)
* mpeg mode: transport
* signal: digital compander MPEG2
* Requires a digital compression satellite receiver capable of
receiving a DVB stream is needed (Wegener 4000, 500, 396, 400, or 422
are recommended).
Here's the specs of the clone dbv receiver -
TUNER & CHANNEL
Input Connector F-Type female IEC169-24
Frequency Range 950 - 2150 MHz
Demodulation QPSK
Symbol Rate 2-45 Msps
Input Level -65 dBm ~ 25dBm
Input Impedance 75 ohms
LNB Power 13/18 V DC, Max. 500 mA
DiSEqC Control Version 1.3 Compartible
Band Switching 22 KHz Tone
Viterbi Decoding Rate 1, 2/3, 3/4,5/6,7/8
MPEG TRANSPORT STREAM & A/V DECODING
Transport Stream MPEG-2 ISO/IEC 138-18-1
Input Rate Max. 90 Mbit/s
Video MPEG-2 MP@ML
Video Resolution Max. 720 x 480
Aspect Ratio 4:3 - Normal TV, 16:9 Wide TV
Audio Decoding MPEG-1/2 Audio Layer I & II
Audio Mode Single/Dual Channel, Stereo, Joint Stereo
MAIN SYSTEM
Main Processor STi5518 (ST2D 32 bit, 81 MHz)
Flash Memory 2 Mbyte
SDRAM 8 Mbyte
CPU Clock 81 MHz
EEPROM 32 Kbit
RF MODULATOR
PLL type Ch 21-69 for the modulation
RF Connector 75 Ohm, 169 - 2, Male/ Female
TV Standard PAL B/G, I, SECAM L, NTSC M selectable
Frequency Range UHF:470~860 MHz
A/V & Data OUTPUT/INPUT
IF Input IEC1692 Male/Female
IF Loop-through Output 1 x F type
RCA Jack CVBS Audio L, R 0/12 DC out
Serial Port RS-232C Bound Rate 115200, 9 Pin D-Sub
I guess what I'm asking is
1) is a 20" dish big enough?
2) do I need a different lnb?
3) will this receiver receive/decode the signal?
Thanks in advance for your advice or direction.
Navigation:
[Reply to this message]
|