|
Posted by Lars-Erik sterud on 09/30/77 11:47
Bob:
> Look at the active side of that disc with a strong light and
> magnifying glass. Look for a 1 mm long streak somewhere along the
> outer bands.
The spot is clearly visible AFTER the burn (then it looks like the
whole disk does before the burn). But not visible before the burn
(and that is a bit sad, since I can pick out the bad ones before)
> bad discs that would have otherwise been considered good until I found
> out the hard way that they were bad.
Strange thing is that a test read (PIE) shows no more errors than on
the rest of the disk (no peaks) and a verify show no errors either. Is
the error correction/redundancy so good that it handles a 1 mm spot)?
--
Lars-Erik - http://home.chello.no/~larse/ - ICQ 7297605
Navigation:
[Reply to this message]
|