|
|
Posted by Maurice on 05/11/06 13:08
Like I said, I accept one channel but why is it outputting from the card
from only a surround sound socket and not the front speaker(s) like every
other tape not shot on the Z1. Perhaps the cameraman made a mistake in his
settings but I cannot contact him and I don't know enough about the Z1 to
know whether he COULD have made a mistake creating this situation. Sure, I
can use the output I DO have but it isn't the right one.
--
Maurice Fleisher: <maurice12@ntlworld.com>
High Wycombe. UK
"Ty Ford" <tyreeford@comcast.net> wrote in message
news:BeednUZs06TD7f_ZRVn-iw@comcast.com...
> On Wed, 10 May 2006 16:09:56 -0400, Maurice wrote
> (in article <oMr8g.2545$fS1.2480@newsfe6-win.ntli.net>):
>
>> I have been given some tapes to edit shot in DVCAM format on a Sony Z1.
>> To
>> the best of my knowledge all the sound (voice only) was recorded using a
>> radio mic.on one channel.
>>
>> NLE is Pinnacle Liquid Edition 6.1 SP2.
>>
>> Everything appeared to capture fine and I hear audio from the deck whilst
>> capturing but I am getting audio out from the sound card only on one
>> socket,
>> the woofer/centre socket. Absolutely nothing on the other output sockets.
>> I
>> don't think it is full spectrum out but it sounds about right for a
>> centre
>> out, i.e. voice frequencies All other tapes shot on other cameras are
>> fine
>>
>> Anybody have any ideas? Odd non-compatible audio on the Z1 or faulty
>> camera
>> or faulty mic connection, etc., etc. Never had anything like this before.
>> I
>> am at a loss but hesitate to get my own Z1 until I know the answer
>>
>>
>>
>
> Sorry, I failed to read the DVCam part correctly. DVCam does give you
> 16-bit
> , 48 kHz. But the issue, I think is stiil, you recorded on one mic to one
> channel.
>
> Ty Ford
>
>
> -- Ty Ford's equipment reviews, audio samples, rates and other
> audiocentric
> stuff are at www.tyford.com
>
Navigation:
[Reply to this message]
|