Posted by Andrew Rossmann on 12/22/06 21:49

[This followup was posted to rec.video.dvd.players and a copy was sent
to the cited author.]

In article <1166817861.326624.8860@73g2000cwn.googlegroups.com>,
michaeljc70@hotmail.com says...
> I have DVD player that I would like to send the output to 2 tvs at a
> time. I tried splitting with no luck (signal too weak). If I hook one
> up the the composite video and another to the S-Video, will that work
> or does it only send a signal strong enough for 1 output?
>
> This is a run-of-the-mill Panasonic DVd player (don't know the model).

All outputs should be active and can be used simultaneously. The main
issue could be if you configure it for Progressive scan, as the
composite and S-Video may then become disabled or output garbage.

--
If there is a no_junk in my address, please REMOVE it before replying!
All junk mail senders will be prosecuted to the fullest extent of the
law!!
http://home.att.net/~andyross

• Next in forum: Re: Do DVD players output to all outputs at once?
• Prev in forum: Do DVD players output to all outputs at once?
• Thread view: Re: Do DVD players output to all outputs at once?

[Reply to this message]