|
|
Posted by rebus on 05/12/07 00:49
In article <K_KdnXuJKem0Gt3bnZ2dneKdnZydnZ2d@comcast.com>,
Rick Merrill <rick0.merrill@NOSPAM.gmail.com> wrote:
> rebus wrote:
> > In article <1178539068.156179.209910@l77g2000hsb.googlegroups.com>,
> > d_moor@yahoo.com wrote:
> >
> >> I have two movie clips which I have concatenated in Final Cut Studio.
> >> I have added chapter markers so that DVD Studio will use them to
> >> create chapter menus. However, after doing the export to a quicktime
> >> move, only the chapter markers from the 2ond clip are shown. There
> >> are no chapter markers for the 1st clip - all 10 have been dropped.
> >>
> >> 1. Is there a way to fix this?
> >> 2. If not, is there a way to export the markers to a text file from
> >> FCP, so that I can import them to DVD Studio?
> >>
> >> Thanks!
> >
> > 1. Yes, see 2.
> > 2. Just add the markers in DVD Studio.
> >
> > Notes: in FCP you must add chapter markers in the timeline or canvas.
> > You can concatenate in DVD studio.
> > You can save time by exporting with Compressor
> > directly to MPEG video and Dolby digital audio.
>
> Pardon my ignorance, but I would like to find out
> how can Compressor export MPEG2 at 720x480, 29.97 fps, vbr
> audio in Layer 2 stero at 48.0 KHz with bit rate of 224 kbps.
You can't, DVD audio is either 16-bit PCM or Dolby or DTS.
If you give DVD Studio Pro any other type of file it
will convert it in the background.
Compressor has presets for various quality levels, give it a look.
Navigation:
[Reply to this message]
|